Liros GrainWatch HCS GDC D1, Техническое описание

Страница: 4 / 12

HCS GDC D1
TECHNICAL DESCRIPTION
APRIL 2019
2. Manual Mode
4
Manual Mode – MAN – is a simple time-based pro-
gram in which drying times are set with a percentage
value that shows how much of the time the feed-out is
active.
Example: If MAN is set to 10%, the feed-out is run-
ning 10% of the time and inactive 90%. If the value is
set to 50%, the feed-out will run and be idle in a 50/50
relation, and so on.
It is recommended to move the dried commodity
to a wet silo so that damp cereals can continuously be
fed into the dryer. Check the moisture content of the
dried product regularly. If the outgoing grain is too wet,
lower the setting on the panel. Is the item instead is too
dry, raise the value.
When the desired moisture content is reached,
press “Auto Set “ after which the system will automati-
cally set a value corresponding to the one used in
Manual mode.
If the “Auto” button is pressed directly without pre-
setting, the control automatically switches to the last
setting previously used by the auto function.
Press “Man”
Step 1
PV : Shows the signal from the sensor.
Man : Shows the percentage set.
Feed Out : Lights up yellow when output is
active.
– : Decreases the set percentage (drier item).
+ : Increases the set percentage (wetter item).
Auto
: Go to the Auto screen to set the control
on the auto value that was used the last time
auto mode was used.
Auto Set: To go to Auto, where the controller
loads a new auto value with respect to the
signal from the sensor (PV) and the percent-
age used when pressing the button.
Main : To go to the Home screen.
Step 2
NOTE: When The dryer is empty, the signal value “PV” should be
4.00. If it is below 3.70 or above 4.30, the equipment needs service
and calibration.