15
2020-03
Installation
15
Subject to change. |
Data bus (input)
Modbus RS485 A
Terminal assignment
Modbus RS485 B
Modbus shield
Data bus (output)
Modbus RS485 A
Modbus RS485 B
Modbus shield
Cable connections
4.2.6
Attaching the connecting cables
¨
Check that the connected strands are secure before you complete the installation work and
close the
iFerm Nano Terminal
.
¨
Securely tighten all cable screw connections on the inside and outside in order to ensure strain
relief and no leaks.
Information
Even if you are not immediately integrating
iFerm Nano Terminal
into your
network or connecting it to an end device, you should make the device’s
internal Ethernet connection straight away. This means that later on you
only have to insert an Ethernet cable into the plug of the cable screw con
-
nection without having to open the device again.
¨
When you are fitting the housing cover, connect the short Ethernet cable in the device to the
Ethernet socket in the display. When doing so, take care above all not to break off the plug’s
latching tab when releasing the plug (press down the latching tab).
¨
Close the housing and secure it with the quick-release fasteners.
Attention!
If you open
iFerm Nano Terminal
again later, you must detach the Ether
-
net cable in the device (when doing so, press down the plug’s latching tab
so that it does not break off)
.
DE
EN
DE
DE
DE
DE
DE
DE
