Liquid Controls LectroCount3, Руководство по установке

Страница: 23 / 44

23
11.5 RSCB MOUNTING BOLT PATTERN
The RSCB base casting contains eight mounting holes in an industry standard bolt
pattern that allow it to be easily attached to a number of common meters. All of the
holes are ½” deep and will require .250-20 screws.
q
When mounting the RSCB leave the
cover assembly fastened to the base
to protect the internal components.
q
Before securely fastening the RSCB
to the meter or bracket, make sure
that:
§
The remote electronic counter
(REC) is visible.
§
The multi-position switch can be
easily operated.
q
If the RSCB will be exposed to the
elements before the installation is
complete, make sure that the cover
gasket is in place and that all (12)
7/16” mounting bolts and washers
are installed.
q
Remove all of the pipe plugs from
the RSCB’s seven ½” NPT conduit
hubs. Apply pipe sealant or Teflon
tape to the threads, then re-install
the plugs in the ports.
Refer to the above drawing if you will
need to fabricate a mounting bracket
for the LectroCount
3
RSCB. Brackets
and adapters are available for many
common meters.
NOTE: If the RSCB was not pre-wired from the factory then refer to the wiring diagram in
the back of this manual to assist in field wiring. Terminal block numbers, signal
functions, and wire colors can be found there. Please read the special notes listed on
the drawing.
Liquid Controls will not honor any warranty claims for damage due to
negligence during the installation of the
LectroCount
3
system.