Lipco UF 100, Перевод оригинальной инструкции

Страница: 18 / 28

Instructions Reversing Harrow UF 70/80/90/100 _ 70L
18 - 28 110030-11-EN BA UF 70_80_90_100 UF 70 L / 29.06.2020
13. Maintenance
In order to maintain the machine in good working condition, carry out
following steps:
•
Grease the roller bearings on both sides (Fig. 10).
Bearing on both ends of grid
roller
Fig. 10
•
Check the oil level in the angular gear (Fig. 8). Oil level 2-3 cm in
horizontal gear drive position. Make the first oil change after 30 to
50 operating hours. Further oil changes after every 200 operating
hours or once a year. Use gear oil SAE 90. (Amount of oil 0.3 L)
Oil filler neck to check oil level in
gearbox.
Fig. 11
•
Tighten all cutting blade screws. Replace damaged screws
immediately (refer to chapter "14. Replacement of the cutting
blades"). Note: Always use the original steel nuts with fine pitch
thread.