Lionelo Fidi Go, Руководство пользователя

Страница: 6 / 64

‑ 6 ‑ EN
The product complies with requirements of EU directives.
Pursuant to the Directive 2012/19/EU, this product is subject to selective collection. The product must not
be disposed of along with domestic waste since it may pose a threat to the environment and human health.
Worn-out product must be handed over to the electrics and electronics recycling point.
Device outline (fig. 1)
1. Protective cover
2. Silicone funnel
3. Breast pump T-connection
4. Membrane cover
5. Silicone membrane
6. Suction valve
7. Milk bottle
8. Main motor
9. Tube
10. Milk bottle cap
11. USB cable
12. Milk bag adapter
13. Milk bag
Touch screen outline (fig. 2)
1. Massage and suction display
2. Milk stimulation mode
3. Mode switching
4. Level down
5. Battery indicator
6. Milk drawing mode
7. Level up
8. On/off switch
Breast pump modes (fig. A)
1. Milk stimulation mode – 5 levels. Massage stimulates initial child suction phase while breastfeeding.
2. Milk drawing mode – 9 levels. This mode stimulates deeper child suction phase while breastfeeding.
How to install
1. Position the silicone funnel (2) on the breast pump T-connection (3). Make sure the funnel flange
is properly attached (fig. 3).
2. Place the silicone membrane (5) on the breast pump T-connection (3). Make sure the membrane flange
is properly attached (fig. 4), and then put the membrane cover (4) on.
3. Insert the suction valve (6) into the lower hole of the breast pump T-connection (3). Make sure the
valve is pushed as fast as possible. Note: insert the suction valve gently to avoid damage. Do not
use the valve (fig. 5) if it is damaged.
4. Screw the milk bottle (7) to the breast pump T-connection (3). Insert the tube (9) into the hole in the
membrane cover. Connect the membrane cover to the main motor (8) with the use of the tube (fig. 6).
Make sure the tube is tight to prevent air from escaping.
5. If you want to keep milk for future use, screw the adapter (12) to the milk bag (13), and then screw everything to
the breast pump T-connection and connect T-connection to the main motor (8) with the use of the tube (9) (fig. 7).