Y
our Pylon is illuminated by one 18-volt lamp. During the course of normal operation,
this bulb may require replacement. Follow these steps to replace the lamp with part
no. 612-3011-311.
1. Lift the support arms of the airplanes out of the tubes at the top of the
pylon. Also, remove any screws securing the base to your layout.
2. Remove the four screws from the underside of the base with a small
Philips-head screwdriver and lift away the roof and pylon tower. Refer to
Figure 5 on page 10 for the location of the screws.
3. Locate the lamp in its small, black fixture. Carefully pull the lamp straight
up and out of the socket. Refer to the Figure 6 on page 11 for the lamp
location.
4. Install the replacement lamp. Line up the bottom of the bulb with the
socket and carefully push the lamp down into place.
5. Reassemble the Pylon, following these steps in reverse order.
Replacing the lamp on your WWII Airplane Pylon
9
