17
LEGACY and Command Control Remote
Operations
Adjusting the volume from your LEGACY remote
I
n addition to the physical volume control under the hatch of your VISION Reefer (see page 5),
your remote can be used to adjust the overall volume, or just the volume of the background sounds
(which include bump, grind, and rail clatter).
Pressing the volume up or down buttons (see pages 12 or 15) adjusts the overall volume of your
VISION Reefer car. A single bell ring will be heard each time the volume is raised or lowered, except
that no ring will be heard once the volume reaches the minimum or maximum levels.
Be aware that if your Min/Max switch is in the Min position, adjusting the master volume
or blend volume from your remote will have essentially the same result.
To adjust the overall volume of the reefer, follow the instructions above except do not
press AUX1. Only press the volume up or down buttons.
To adjust only the levels of the background sounds in LEGACY mode, such as rail clatter, bump and
grind sounds:
1. If assigned to a Train, press Train Link, or address your Reefer Car directly by pressing ENG and its
ID.
2. Press AUX1 first, then press the volume up or down keys on your remote.
3. Press the Train Link button to continue controlling your train.
In this case, a metallic clank sound will confirm the background or “blend” sound volume is being
adjusted. Again, this confirming sound will not be heard when the background/blend sound volume
reaches its minimum or maximum level.
Note!
Note!
