Lionel Freedom, Руководство пользователя

Страница: 15 / 28

15
Tuning your locomotive’s performance
MOMENTUM
TrainMaster Command Control’s
momentum feature simulates the labored
performance of a locomotive pulling a
heavy load. Press
L , M , or H (located under
the CAB-1 Remote Controller’s removable
panel) for light, medium, or heavy
momentum. The locomotive’s Command
reverse unit remembers this setting until
you change it. For quick locomotive
response, choose
L .
BRAKING AND BOOSTING
There’s more to starting and stopping
than just turning the CAB-1 Remote
Controller throttle. Use the
BOOST and
BRAKE command buttons—they give you
incremental control of speed and are the
superior way to handle grades, gradual
stops-and-starts, and more. Plus, using
BRAKE in the Command environment
gives you a bonus RailSounds effect—the
ultra-realistic sound of squealing brakes.
SOUND QUALITY
To achieve your preferred RailSounds
sound system master volume level, we
recommend that you adjust your locomotive
volume control knob (see Figure 3 on page
8 for the location). Turn the knob left or
right to reach the desired volume level.
For quick remote-control of volume
below the master setting—for example,
muting—use the CAB-1 Remote Controller
numeric keypad’s volume control. Press
AUX1
and then
4
on the numeric keypad to
lower the overall RailSounds output.
HIGH VOLTAGE SETTING
Press SET , and the headlight will flash.
Get your locomotive moving to the
maximum speed you want it to run, then
press
BOOST . Use this to keep your
locomotive from derailing at excessive
speeds. Turn off the high voltage setting by
pressing
SET , then BOOST , holding each
for one second.
STALL
Make your locomotive feel more
responsive by setting a “stall” voltage. Get
your locomotive moving, then press
SET ;
the locomotive will stop. Turn the throttle
clockwise to get the locomotive moving,
then decrease speed until the locomotive
just stops. Press
SET again; the Command
reverse unit remembers the stall setting
until you change it. To clear the stall
setting, press
SET
twice, holding it for one
second each time.
These settings will be lost when you assign a new engine ID number.
Note!
TrainMaster Command operations