–
–
–
–
2
3
Ordering Information
Part Number
Description
MDEV-***-HH-LR8-HS
HS Long-Range Transmitter Master Development System
*** = 315, 418 (Standard) or 433.92MHz
Ordering Information
Figure 2: Ordering Information
1. 9V Battery
2. Power Jack
3. On-Off Switch
4. Voltage Regulator
5. QS Series USB Module
6. Prototype Area
7. Break-Out Header
8. RP-SMA Antenna Connector
9. LR Series Receiver
10. HS Series Decoder
11. Data Line LEDs
12. Indicator LEDs
13. Function Switches
14. LEARN Button
15. SEND_KEY Button
16. CREATE_KEY Button
17. Key Input Jack (for hardwire key
transfer)
18. IR Receiver Enable Button
19. IR Key Transfer Phototransistor
and Diode (for IR key transfer)
20. Key Output Jack (for hardwire
key transfer)
HS Series Decoder Development Board
2
3
4
5
1
Figure 3: The HS Series Decoder Development Board
6
7
8
9
10
11
12
13
14
15
16
17
18 19
20
Using the Development Boards
After unpacking the development system, attach an antenna to the
decoder board, install the 9V battery and turn on the power switch.
The
encoder and decoder are set at the factory to work straight out of the
box.
To create a new operational setup, follow these steps:
1. On the decoder board, press and hold the LEARN button and then
press the CREATE_KEY button to enter Create Key Mode. Release
the LEARN button and press the CREATE_KEY button ten times to
generate the KEY.
2. Press the GET_KEY button on the back of the transmitter to activate
the IR receiver. Hold the back of the transmitter close to the decoder
boards's IR key transfer area until the MODE_IND LED turns on.
3. Set Control Permissions by pressing the LEARN button on the decoder
board.
4. While the decoder's MODE_IND line is flashing, press each button on
the transmitter that is to be granted recognition permission.
5. After all the desired data lines have been transmitted, press the
LEARN button again, or wait until the 15 second time-out occurs. The
permissions are now saved in the decoder.
6. Transmit with one or all of the authorized data lines to confirm that the
learn process was successful.
Troubleshooting
If the boards fail to work out of the box, then try the following:
•
Check the batteries to make sure they are not dead and that the
antenna is connected.
•
Make sure the baud rate switch is set correctly on the decoder board.
•
Make sure the Encryption Key is set correctly. It is created by
the decoder and must be sent to the encoder before they can
communicate.
•
Make sure that the Control Permissions are set correctly. If the
transmitter has not been set to use a particular line, then when a
button on the transmitter is pressed, the MODE_IND LED on the
decoder board lights up, but the data line LED does not light up.
If all of these appear to be in order, then call +1 800 736 6677 or e-mail
[email protected] for technical support.
