9 Important Information
9.1 Information on the Use of this PC Card
This card has been designed only for controlling 2-phase stepping motors and may not be modified in
any way. If any malfunction occurs, please be sure to contact our Service Department (for a list of
addresses, please refer to Chapter on Service). LINOS shall not be liable for any direct, indirect or
consequential damage, particularly if such damage is caused by negligence, and no matter whether
such damage arises in connection with the warranty, a contract, an offence or a further legal theory.
The electrical equipment described (apparatuses, systems, installation and networks) is only intended
for use in industrial or scientific areas. Compliance with the legal requirements and directives
concerned is essential.
If used incorrectly, this electrical equipment may generate hazardous voltage or may have “live” parts
during operation. Removing the required covers or inadequate maintenance may severely endanger
or impair the health of individuals or cause material damage. Therefore, the person responsible for the
safety of the equipment must ensure that
•
only qualified personnel are entrusted with working on or operating the equipment and
machinery;
•
these persons always have the appropriate instruction manual and any additional product
literature as necessary for all operating steps and servicing and repair work, and that such
persons are obligated to observe these instructions and information at all times;
•
work on this equipment and machinery or in their vicinity is prohibited for non-qualified
personnel.
Qualified personnel are persons who by virtue of their education, experience and training as well as
their knowledge of the pertinent standards, requirements, occupational and work safety regulations
and operating conditions have been authorized by the person responsible for the safety of the
installation or system to perform the work as required and can recognized and prevent any potential
hazards (see definitions for skilled labor according to VDE 105 or ICE 364).
This information is not exhaustive. If you have any questions or problems, please contact LINOS
Photonics GmbH & Co. KG.
The information on processes explained in this instruction manual and circuit details apply analogously
and must be reviewed before actually applying this information to your specific application.
LINOS Photonics GmbH & Co. KG shall not assume any guarantee for the suitability of the
procedures and suggested circuits for specific applications.
The information in this instruction manual describes the features of the product without expressly
assuring such characteristics.
We have carefully tested the equipment hardware and software as well as the product literature.
However, we do not make any warranty that they are free of errors.
The content of this document is the intellectual property of LINOS Photonics GmbH &Co. KG and is
subject to copyright protection laws. Reproduction of any of these materials is not permitted unless our
prior written consent is obtained.
Our products continuously undergo further development. We reserve the right to make changes
without prior notice. At the Internet address http://www.linos.com you will find information and, where
available, update possibilities.
M50.PCI 21
40
2310
