LINNEPE 303405, Быстрый старт

Страница: 11 / 12

flashing red and green LED for 20 seconds. During this
time TriGasAlarm will check the concentration of the gas
detected. If the concentration is the same or higher an
Alarm will be created. The Alarm is indicated through flashing
red LEDs light and an alarm sound.
Function-Examination
1.) Switch on TriGasAlarm, wait until the self-test has
ended and the green LED constantly shines.
2.) Hold a gas-lighter to the lateral openings of the TriGasAlarm,
you press the button of the lighter, so that gas streams out,
but no flame is generated.
3.) After a few seconds, the prealarm is caused. Keep on
bringing gas into the alarm for the next 20 sec. and you will
cause the Main-Alarm.
Option:
As an option you can connect a second Sen-
sor with TriGasAlarm. The optional Sensor
has the same capabilities like the original
in the TriGasAlarm. With the second sensor
you get a much higher level of safety no matter
if gases are lighter or heavier than the air surrounding you. The
second sensor will be installed approximately 10 cm underneath
the ceiling.
11