Copyright © 1991-1997 by Linn Products Limited. All Rights Reserved.
Page 33
Revised Dec 97
Index
TO MODIFY OLD HELIX AND NEXUS TO
INCORPORATE KUSTONE STANDS
(WITHOUT TOP PLATE)
Only required for Helix prior to serial number 10,559/600
Only required for Nexus prior to serial number 19,487/8
Tools Required:
No. 2 pozidrive screwdriver
M4 allen hex key
Soldering iron 50 - 100 W (temperature controlled)
Solder
Drill with 7 mm bit
M5 screw (short arm collar screw)
5 mudguard washers (LP12 kit)
Components Required:
4 x M5x12 inserts
4 x M5 washers
Template
Instructions:
1.
Clean work area/bench of anything that might damage the cabinet. Re
member wood is easily marked - protect cabinet from bench, tools, loose
screws etc.
2.
Check that inserts will thread properly on Kustone rods.
3.
Remove trim ring (or facia) from bass unit of speaker and remove bass
fixing screws.
4.
Lift out and de-solder bass unit. Place to one side in a safe place along with
rubber gasket.
5.
Place speaker upside down on a clean, soft surface or bench mat.
6.
Locate template on speaker and mark centre of holes.
7.
Drill holes with 7 mm drill.
8.
Remove side of foam pad inside speaker to gain access to bottom enclosure
of speaker. Place washer on the insert and locate in hole from inside the
cabinet.
9.
Use Ittok/Ekos arm collar screw (M5) and five mudguard washers to pull into
place. tighten until insert is fully located. Check washer fitted inside cabinet
does not turn. Reglue side of foam inside cabinet.
10.
Re-assemble speaker, soldering wires to unit and securing in position.
11.
Re-attach facia or trim ring (glue in place with silicone sealer).
12.
Carry out modification for the other loudspeaker.
13.
Fit stands and audition loudspeakers.
Estimated Time
of Completion for
this task ~
30 minutes
MODIFYING HELIX & NEXUS FOR KUSTONE STANDS
Содержание KELTIK
Страница 1: ...LOUDSPEAKERS LINN...
