high output level, while some tuners produce quite a low output. On a conventional
pre-amplifier, when switching from one source to another, the volume control must
be adjusted to maintain the same listening level.
The KAIRN pre-amplifier can be set to adjust the volume setting automatically to keep
the listening level constant when switching between sources. This can be done
as follows:
Connect all sources to the pre-amplifier, switch them on and set them to
play music.
Select the “volume” display mode by pressing VOLUME on the front panel
(or VOL-, or VOL+ on the remote handset).
Press and hold the VOLUME button again (or the 0 button on the handset)
until the message SETUP appears on the display.
Select one of the sources (as described earlier) and adjust the volume level
to about 50.
Select each of the remaining sources in turn and, for each, adjust the vol-
ume setting so that the same listening level is heard.
When all adjustments are complete, repeat steps 2 and 3 above, but note
that the message OFFS appears on the display.
The volume can now be turned up or down to the desired listening level and this
level will be maintained for all sources.
USER SELECTABLE OPTIONS
The user can customise operational features of the
pre-amplifier to suit personal preferences.
To do this enter the “user function” mode. First, switch off the pre-amplifier.
Press and hold either the
MONO
or the
MUTE
button pressed until the display
changes to U1.
To step up or down through the user functions, press the
MONO
or
MUTE
buttons
respectively. The user functions are displayed as U1-U6. The status of each
function is shown by the number on the right of the display. To step through the
options for each function, use the
+
or
-
buttons (or the VOL+ or VOL- buttons
on the handset).
1
2
3
4
5
6
10
KAIRN ENG PLACED 11/27/02 9:27 AM Page 15