LinMot E1100-CO, Технический паспорт привода и руководство по установке

Страница: 21 / 27

Installation Guide E1100
LED Blink Codes
Description
ERROR WARN EN
OFF Warning Operation
Enabled
Normal Operation. Warnings and Operation Enabled are
displayed
On  ~ 2Hz
0..15 x
Error Code
High Nibble
 ~ 2Hz
0..15 x
Error Code
Low Nibble
Error: The Error Code is shown by a blink code with “WARN”
and “EN”. The Error Byte is divided into Low and High Nibble.
”WARN” and “EN” are blinking together. The error can be
acknowledged.
(ex.: WARN blinks 3x, EN blinks 2x; Error Code = 32h
 ~ 2Hz  ~ 2Hz
0..15 x
Error Code
High Nibble
 ~ 2Hz
0..15 x
Error Code
Low Nibble
Fatal Error: The Error Code is shown by a blink code with
“WARN” and “EN”. The Error Byte is divided into Low and High
Nibble. ”WARN” and “EN” are blinking together. Fatal Errors
can only be acknowledged by a reset or power cycle
(ex.: WARN blinks 3x, EN blinks 2x; Error Code = 32h
 ~ 4Hz  ~ 2Hz
0..15 x
Error Code
High Nibble
 ~ 2Hz
0..15 x
Error Code
Low Nibble
System Error. Please reinstall firmware or contact support.
 ~ 0.5Hz  ~ 0.5Hz On Signal Supply 24V too low: The error and warn LEDs blink
alternating if the signal 24V (X4.2) is less than 18VDC.
M
●
~4Hz
●
M
~4Hz
Off Waiting for Defaulting Parameters
When ID (S1, S2) is set to 0xFF, the drive starts up in a special mode
and the Error and Warn LED blink alternating ~4Hz. When the ID ist
set to 0x00, all parameters will be set to their default value. To leave
this state, power down the drive and change the ID. Also see in the
Usermanual_LinMot-Talk under chapter trouble shooting.
Off
M
●
~2Hz
M
●
~2Hz
Defaulting Parameters Done
When the parameters have set to their default values (initiated via
S1/S2 on power up) the Warn and En LEDs blink together at 2 Hz. To
leave this state, power down thedrive. Also see in the
Usermanual_LinMot-Talk under chapter trouble shooting.
The meaning of the Error Codes can be found in the Usermanual_MotionCtrl_Software_E1100 and the
user manual of the loaded interface software. These documents are provided together with LinMot-Talk
configuration software and can be downloaded from
www.linmot.com
.
NTI AG, LinMot Installation Guide E1100 23/08/2018 Page 21 / 27