Installation
Chapter
24-Port 10/100 + 2-Port 10/100/1000 Gigabit Advanced Smart Switch with 2 Combo SFPs
Desktop Placement
Attach the rubber feet to the recessed areas on the
bottom of the Switch.
Place the Switch on a desktop near an AC power
source.
Keep enough ventilation space for the switch and
check the environmental restrictions mentioned in the
Specifications
Appendix as you are placing the Switch.
Connect the Switch to network devices according to
the Hardware Installation instructions below.
Rack-Mount Placement
When rack-mounting the Switch, please observe the
following guidelines:
Elevated Operating Ambient
If installed in a closed
or multi-unit rack assembly, the operating ambient
temperature of the rack environment may be greater
than room ambient. Therefore, consideration should
be given to installing the equipment in an environment
compatible with the maximum ambient temperature
(Tma) specified by the manufacturer.
Reduced Air Flow
Installation of the equipment
in a rack should be such that the amount of air flow
required for safe operation of the equipment is not
compromised.
Mechanical Loading
Mounting of the equipment in
the rack should be such that a hazardous condition is
not achieved due to uneven mechanical loading.
Circuit Overloading
Consideration should be given
to the connection of the equipment to the supply
circuit and the effect that overloading of the circuits
might have on overcurrent protection and supply
wiring. Appropriate consideration of equipment
nameplate ratings should be used when addressing
this concern.
Reliable Earthing
Reliable earthing of rack-mounted
equipment should be maintained. Particular attention
should be given to supply connections other than
direct connections to the branch circuit (e.g. use of
power strips).
To rack-mount the Switch in any standard 19-inch rack,
follow the instructions described below.
Place the Switch on a hard flat surface with the front
panel faced towards your front side.
Attach a rack–mount bracket to one side of the Switch
with the supplied screws and secure the bracket
tightly.
•
•
•
•
•
•
•
•
•
1.
2.
Attaching the Brackets
Follow the same steps to attach the other bracket to
the opposite side.
After the brackets are attached to the Switch, use
suitable screws to securely attach the brackets to any
standard 19-inch rack.
Mounting in Rack
Connect the Switch to network devices according to
the Hardware Installation instructions below.
Hardware Installation
To connect network devices to the Switch, follow these
instructions:
Make sure all the devices you will connect to the Switch
are powered off.
Connect a Category 5 Ethernet network cable to one
of the numbered ports on the Switch.
Connect the other end to a PC or other network
device.
Repeat steps 2 and 3 to connect additional devices.
If you are using a miniGBIC port, then connect a
miniGBIC module to the miniGBIC port. For detailed
instructions, refer to the module’s documentation.
Connect the supplied power cord to the Switch’s
power port, and plug the other end into an electrical
outlet. When connecting power, always use a surge
protector.
3.
4.
5.
1.
2.
3.
4.
5.
6.
