The Linksys LGS108P switch is compliant with IEEE 802.3, 802.3u, 802.3x, 802.3ab, and 802.3az standards.
8. Can I wall-mount my switch?
Yes, the Linksys LGS108P can be wall-mounted.
9. What should I do if my switch experiences excessive data collisions?
Verify that your network cabling is securely crimped and installed properly.
10. Is my switch capable of Jumbo Frame Support?
Yes. The Linksys LGS108P supports Jumbo Frames.
11. Can I use a switch to share Internet connection to all computers in the network?
No. The switch is not capable of sharing Internet connection across the network. However, what it does is that it allows more computers to be
connected to a local network.
NOTE: Only routers or modems with DHCP capabilities can allow sharing of Internet connection between computers.
12. Which ports on my PoE switch can I plug in a PoE device?
You can plug the PoE device to the switch’s four (4) Ports (1-4).
13. How is port PoE prioritization done?
The switch has a feature called PoE prioritization where power is provided based on port priority for PoE devices connected to the PoE ports.
This follows the criteria below:
a. Port ID1 has higher priority.
b. The higher the Port ID, the lower the priority.
c. Rebooting the switch reprioritizes PoE per port.
NOTE: This is only applicable for those ports that have a PoE device connected to it.
An example is if all three (3) PoE devices have maxed out the power budget on the switch. When a fourth PoE device connects, since it
exceeds the power budget, the connection is declined and Port 4 will not provide power to a PoE device. However unplugging Port 1 will then
provide power to Port 4 for the PoE device connected to it.
QUICK TIP: If the device is a non-PoE device this behavior does not apply.
If the PoE device is reconnected back to Port 1, Port 1 remains OFF. In order to restore power to Port 1 for the PoE device either unplug PoE
device from Port 4 or reboot the switch. Rebooting the switch prioritizes PoE for each port all over again.
14. What is the warranty period for the Linksys LGS108P?
Linksys LGS108P has limited lifetime warranty.
15. What are the supported PoE standards?
The switch only supports IEEE 802.3af and IEEE 802.3at. Any PoE devices not supporting these standards will not be powered ON by the
switch.
16. My PoE device is not powering ON, what should I do?
If your PoE device is not powering ON, do the following:
Verify with the vendor if it supports IEEE 802.3af and IEEE 802.3at. The switch only supports these PoE standards.
Make sure your PoE device is connected to a PoE port.
If you have several PoE devices already connected to the switch, you may have exceeded the power budget of the switch.
Содержание LGS108P
Страница 3: ......
