Linkcom France
11 rue du Soleil Levant 92140 CLAMART Copyright © 2011 – Linkcom – All rights reserved
9
3.2. SIM preprogramming
1.
Put the SIM card SIM on a mobile phone.
2.
When PIN is setup, cancel it (or setup code 1234)
3.
Save the remotely administrator number under name “ADMIN1” on the phonebook of
SIM card.
4.
Save the number that should be dialed after pressing button1 under name “ABOUTTON1”
5.
If you want dial automatically next numbers (when first number is busy or not available) then
save those numbers under appropriate names “ABUTTON2” to “ABUTTON7”.
6.
Similarly you can program setting of all parameters (programming table at the end of manual)
The way of phone numbers saving on the SIM depends on mobile phone type.
Please double
check that you save numbers to SIM card and not to internal mobile phone memory!
3.3. Switch ON the GSM DoorPhone
When all necessary cables are connected (relay, locks, Antenna etc.), then connect speaker connector
and connect the power supply. The red LED lights on and after a while yellow LED start flashing. The
GSM DoorPhone informed by tones or by voice SIM reading, GSM network registration and ready for
operation. Now you can put on front panel of GSM DoorPhone but don’t screw it.
When SIM is preprogrammed you can try first connections: push the button. The GDI must dial the
programmed phone number. When SIM is not preprogrammed then first step is SIM programming and
then try connection. After voice connection you can adjust setting of speaker volume. Then screw up
front panel of GSM DoorPhone.
4. Configure the GSM DoorPhone
You can configure the GSM DoorPhone by 2 ways: by SMS or Link GSMDoor Manager software
4.1. Programming by SMS
Due security reasons you can program the GSM DoorPhone parameters from authorized numbers only.
The authorized numbers are saved on SIM card under names « ADMIN1 » to « ADMIN9 ».
The SMS are always written by BIG LETTERS
Each SMS elements are spited by space. First word is always command, the further word is one or more
parameters.
Example:
INIT 330123456789
Please find all commands in table at the end of manual.
1.
For the first use, when the SIM card doesn’t contents any “ADMINx” name, it is necessary to add
the number to the SIM card by SMS with the command “INIT”. The SMS can be sent from any
