© 2017 Linkam Scientific Instruments Ltd.
12
v1.1.0
·
tap the Max vacuum button (2) to set the stage pressure to the lowest it can attain.
·
tap the blue value under Set point (3) to manually set a pressure level
and tap the start button (4) to confirm.
Expansion board setup
All vacuum capable stages will have a vacuum expansion board fitted to their T96 controller, which has the following setup screen, accessed by
taping on the setup bar and taping on the blue arrow:
The only changes that can be made are to switch the displayed units between mBar, mTorr and kPa. This cannot be changed while a profile is active.
Systems shipped with a MV196 motorised vacuum valve will also be fitted with a motor control expansion board:
No changes can be made on this screen, it is for information only.
Pressure stages
This section applies to all stages that can be pressurised to above atmospheric pressure, Including THMS600PS and CCR1000
The only additional information displayed for pressure stages is the pressure, in Bar or Mpa (1). There are no additional controls.
Expansion board setup
All pressure capable stages will have a pressure expansion board fitted to their T96 controller which has the following setup screen, accessed by
tapping on the setup bar and tapping on the blue arrow:
