3
LATCH BRACKET ASSEMBLY (skip to Page 4 for lift assist assembly instructions)
1.
Attach the Latch Bracket to the Rear Mount Plate using the two 1/4” X 1/2” Hex bolts, and the 1/4” hex nut
rear hole.
2.
Attach the Keeper Latch to the Bumper Plate using the two 1/4” X 3/4” Pan head screws. 1/4” Flat washers,
and 1/4” hex nuts.
(See FIG. 2)
3.
Attach the Ramp to the Rear mount plate by sliding the two Hinge Pins towards the center of the Ramp
aligning them to the mount plate and releasing.
4.
Attach the Keeper Bracket to the side of the Ramp using the two 1/4” X 3/4” Pan head screws.
(See FIG. 3)
LINK® MODEL “LB20”
KEEPER
BRACKET
1/4” X 3/4”
PANHEAD
SCREW
1/4 X 1/2 HEX BOLT
1/4” HEX NUT
1/4” HEX NUT
1/4” FLAT
WASHER
KEEPER
LATCH
1/4” X 3/4”
PANHEAD
SCREW
FIG. 2
FIG. 3