Link CAN Gauge, Руководство пользователя, Страница: 2 / 7

Box CoNteNts
• 1 x Link 52mm CAN Gauge
• 1 x Mounting bracket with thumb screws
• 1 x 5’ (152cm) Connection Cable Terminated to DTM-4
• 1 x DTM-4 Mating Connector Kit
• 2 x Link Stickers
tABle of CoNteNts
Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Requirements & Gauge Mounting . . . . . . . . . . . . . . . 2
Link CAN Bus Connection . . . . . . . . . . . . . . . . . . . . . . 3
Terminating Resistor Configuration . . . . . . . . . . . 3-4
Illumination Signal Wiring . . . . . . . . . . . . . . . . . . . . . . 5
Connect to gaugeART CAN Gauge App . . . . . . . . . 5
Create Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Save & Send Configuration . . . . . . . . . . . . . . . . . . . . . . 7
Load Configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
PC Link CAN Stream Configuration . . . . . . . . . . . . . 8
For extended channels . . . . . . . . . . . . . . . . . . . . . . 9-10
Troubleshooting & Support Contact . . . . . . . . . . . . 10
INtro to the 52mm CAN GAuGe
The Link CAN Gauge is a compact 52mm OLED gauge that connects
to Link G4+/G4X ECUs* to display real-time data from CAN broadcasts.
No sensors are added to the gauge – all gauge data is sent from the
ECU over the CAN network. The gauge is wirelessly configurable using
an Android or Apple iOS mobile device through Wifi. Gauge channels,
bar graphs, warning points, and custom gauge labels can be configured
using the CAN Gauge App.
* Works with any CAN enabled Link ECU. Check with Link Tech Support
team if you are unsure of compatibility.
requIremeNts
• Smartphone or Tablet: Smartphone or tablet with Apple iOS or
Android v4.4 or later.
• CAN Enabled Link ECU (G4+ onwards).
GAuGe mouNtING & CABle
INstAllAtIoN:
• Remove the supplied mounting bracket from the rear of the gauge by
unscrewing the two thumb screws from the rear of the gauge.
• The gauge is sized for a 2-1/16” or 52mm mounting hole. Use the
mounting bracket to secure the gauge in place.
• Plug in the supplied cable to the rear of the gauge. Either one of the
two connectors may be used.
• If using more than one Link CAN Gauge, join the two gauges using the
optional daisy chain cable (part no. 101-0227). The last gauge in the
chain will only be connected with the daisy chain cable.
1 2