8
ASSEMBLY OF THE GRINDER
Models BG6 & BG8
1) The Wheel Dresser (A) clips into the plastic holder
on top of the grinder. There is also a place at the rear
of the plastic holder to store the allen (hex)key (B)
which is used to adjust the toolrests.
2) Use the allen (hex) key to loosen the Left Hand
toolrest arm (A), slide the arm forwards as far as it
can go in its slot, and retighten loosely.
Position the toolrest (C) against the front of the
toolrest arm as shown. There are radial grooves in
both the toolrest & arm which should be matched up
to achieve and lock the angle of the toolrest to the
grinding wheel (Usually this is set so that the top of
the toolrest is horizontal)
The toolrest knob/screw (B) can then be passed
through the toolrest casting and screwed firmly into
the arm.
Loosen the toolrest arm again (A) and slide the
assembly towards the grinding wheel until the gap
(D) between the toolrest and the grinding wheel is
no more than 3mm. Retighten the screw (A) firmly.
Rotate the grinding wheel slowly by hand to ensure it
can still run freely.
3) Repeat all steps in operation 2) for the Right Hand
Toolrest assembly.
A
A
B
B
C
D
