9
4) Adjust the Spark Guards at the top of each grinding
wheel so that the gap between the spark guard &
the wheel is no more than 2mm. Rotate the grinding
wheel slowly by hand to ensure it can still run freely.
Note:
As the wheels wear down, the spark guards
must be adjusted to maintain the 2mm gap.
5) The eyeshields should then be fitted to the
guards as shown in the picture.
Note the position of the three washers (A) which
is important to allow the eyeshield to be adjusted
without creating a wear point of the clear plastic
against the sheetmetal of the guard.
The square section under the head of the bolt
fits into the square hole of the eyeshield to lock
the bolt when tightening the knob.
6) The coolant tray can then be fitted to its bracket on
the base of the grinder, just under the switch.
7) The machine should then be securely bolted to a
solid workbench or the optional pedestal stand. The
workbench or stand must be securely attached to the
floor.
8) The last operation before use is to adjust the
worklight by its flexible stalk to a suitable position.
A
