Linhai T-Boss 550, Руководство по обслуживанию

Страница: 195 / 258

CHAPTER 5 FINAL DRIVE
T-Boss550 SERVICE MANUAL 20.0
CHAPTER 5 FINAL DRIVE. 5- 19
13. Carefully remove the shift yoke assembly
from the gearcase cover.
→
Fig 12
Fig 12
14.
Inspect the shift lever ( NO.43 ), shift level
spring ( NO.42 ), shift return spring ( NO.41 ),
shift yoke( NO.45 ), and lock shift bar ( NO.44 ),
Inspect the components for excessive wear or
damage and replace as needed.
→
Fig 13
Fig 13
5.17 REAR GEARCASE ASSEMBLY
Important: Before staring any operation
on the gearbox
，
to ensure that the surface of
all parts is clean .
1.NOTE: The pinion gear assembly is NOT
intend to be disassembled from the case,
as it requires special tooling in order to
properly reassemble. If there is any
damage to the pinion gear, bearings or
case, the assembly must be replace.
→
Fig14
2 .Replace the Oil Seal 30
×
50
×
13.5( NO.16 )
located in the main gearcase and gearcase
cover
→Fig 15
Fig 15
3 .Replace all worn components.
4. If previously removed; assembly the shaft
lever, shift lever spring, shift return springs,
shift yoke, and lock pin bushing.
→
Fig 13
5 .Carefully install the shift yoke assembly into
the gearcase cover.
→
Fig 12
6 .Install the lock shift ( NO.46 ) pin and tighten.
→
Fig 11
7. Install the clutch gear ( NO.25 ) and the
original shims into the gearcase.
→
Fig 16