11-14
line rg o @line rg o .lv
+371 29114991
www.line rg o .lv
c o m fo rt & e rg o n o m ic s
lin
e rg o
1.2 Manual Reset
If a motor or other electronic has been disconnected from the column, during or after the
assembly, a reset (homing) cycle MUST be performed. It is recommended to apply some
pressure on the stand during the reset.
Perform a reset by:
Simultaneously press the up and down buttons. Within a few seconds
the desk will start moving downwards. Keep holding the buttons
and the desk will slowly move the lowest point possible. The reset is
complete when the desk has stopped at the lowest point.
The desk/stand is ready for normal use.
1.3 Collision Detection
This desk is equipped with Collision Detection system designed to avoid possible severe
injury due to pinching. When the desk detects a sudden change in resistance (force) the
desk will stop the movement and reverse approximately 50 mm. The function is active
both while driving up and down but need at least 25 mm of travel to activate.
CAUTION
Always remove the obstacle prior to operating the table again if Collision
Detection have been triggered.
