Linear Lectrotab Autoset II System, Руководство пользователя

Страница: 8 / 9

8
controls may be connected in parallel. Connect the 4 conductor cable from the control to the
Autoset II power/logic module circuit board, at the lower right side, per the drawing on page 9
of this manual. Single flat or bat handle switches, models SF-U or SB-U, are installed in pairs
wherever desired. Any number of pairs may be connected in parallel. See page 9 of this
manual. If switches other than those supplied by Lectrotab are used, contact Lectrotab
Engineering with switch configuration data for a specific wiring diagram.