Linear Logic ScanGauge II, Инструкция по установке и эксплуатации

Страница: 3 / 36

1
I N S TAL L AT I O N
1)
Locate the OBD II Connector
. This connector is normally located
under the dash on either side of the steering column. It can also be
located under the dash on the passenger side in some vehicles. On
rare occasions it is behind the ashtray in the dash or in the armrest. It
may have a cover on it which can be pulled off by hand.
Typical OBDII Connector Location OBDII Plug
2)
Locate a place for the ScanGaugeII
. You can use the sticky-back
velcro supplied with the ScanGaugeII to attach it to the location you
have chosen. The velcro attachment allows you to easily remove it
and use it to trouble-shoot another vehicle and then return it to this
vehicle.
IMPORTANT: Don’t place it on an airbag cover or where it will
be propelled by a deploying airbag.
The location should be where it can easily be seen from the normal
driving position. It should not be placed where it will obstruct the
drivers view outside the vehicle or of other gauges.
3) Route the cable from the OBDII connector and plug the small end of
the cable into the back or side of the ScanGaugeII.
IMPORTANT: A pin in the cable is connected to the vehicle 12V
system. Do not short any pins of the small connector to metal or
other ground when the OBDII Plug is plugged into the OBDII
connector.