Linear Logic ScanGauge II, Инструкция по установке и эксплуатации

Страница: 20 / 36

18
marker. After a few miles see that the Miles changes as you pass the
mile marker. Adjust the Speed up or down to adjust the indicated
distance.
IMPORTANT
: OBSERVE ALL SPEED LIMITS AND DRIVE
SAFELY WHILE MAKING THESE ADJUSTMENTS. THE DRIVER
MUST NOT BE DISTRACTED BY TRYING TO MAKE THESE
ADJUSTMENTS WHILE DRIVING.
NOTE: The adjustment only affects the ScanGaugeII indicated speed
and distance. It does not affect the vehicle speedometer or odometer
readings.
MORE>FILLUP
This screen should be used every time the vehicle is refueled. In order
for the
TO EMPTY
information to be valid, the
TANK SIZE
must
have been properly set and the tank must be filled.
Using this screen will also make adjustments to the fuel consumption
calculations and result in more accurate absolute fuel use and economy
readings.
< 21.6 GALLONS>
0.0% DONE>
The following cautions are important to prevent miscalibration and
inaccurate fuel economy and use.
The accuracy of the ScanGaugeII can be improved if you properly use
the calibration procedure as follows:
1)
Install the ScanGaugeII in the vehicle and set the fuel type, tank and
engine size.
2) Drive to the gas station and fill the tank, letting the pump shut off
automatically.
3) Use the following sequence
HOME>MORE>FILLUP>DONE
. On
this first fillup after connecting the ScanGaugeII II, Don't adjust
the indicated fuel before pressing
DONE
DONE DONE
DONE
>.
4) Keep the ScanGaugeII connected in the vehicle and use the vehicle
normally.