45
DO91304C - DO91305C - DO91306C
www.domo-elektro.be
EN
PARTS
1.
Li
temperature
control knob
2.
Shelves
3.
Vegetable
container
4.
Door shelves
5.
Freezer drawers
6.
Levelling feet
INSTALLATION
· Remove the exterior and interior packing, wipe the outside thoroughly with a soft dry cloth and the
inside with a wet, lukewarm cloth. Dry the appliance off well.
· Do not tilt the refrigerator more than 45° when moving it. Do not apply force to any part such as the
door and its handle in order to prevent the refrigerator from deforming, or else its performance will be
influenced.
· Let air circulate freely around the cabinet. Allow 10 cm of space between the back and both sides of
the refrigerator and any adjacent wall, and 30 cm of space between the top side and the ceiling.
· Make sure there is sufficient space to open the door.
· This cooling unit is not intended for use as a built-in appliance.
· Select a place with a strong, level floor.
· Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources nearby will
cause higher electricity consumption.
· Avoid very moist places. Too much moisture in the air will cause frost to from very quickly on the
evaporator, and your refrigerator.
· Before connecting your refrigerator to the power supply, check that the voltage stated on the rating
label of your appliance corresponds to the voltage in your home. A different voltage could damage the
appliance.
· After installation, leave the freezer for 24 hours before turning it on. This way the refrigerant can
settle.
· Allow the appliance to run empty for 12 hours so the compartment can cool to the appropriate
temperature.
· One can level the appliance using adjustable legs. The adjustable legs can be adjusting by screwing
them in or out of the appliance.
