![LINE2design 70019-Y-BAT Скачать руководство пользователя страница 8](http://html.mh-extra.com/html/line2design/70019-y-bat/70019-y-bat_quick-start-manual_1920926008.webp)
Page | 8
LINE2design, Inc. Battery Powered Wheelchair Stair Climber - Yellow
Item # 70019-Y-BAT
ASCENDING STAIRS
1.
Turn the key on the battery/power unit to the ON position.
2.
Make sure your patient is secure in the chair, double check safety restraint.
3.
Back the chair to the base of the stairs, approximately 10” from the bottom step.
4.
Apply both rear wheel brakes.
5.
Pull the red track release handle toward arrow to release the track, pull away from chair until it locks into place.
6.
Release both rear wheel brakes.
7.
Push the red power button on the control panel to the ON position.
8.
Pull the operator handle to tilt the chair towards you.
9.
Press the green UP button on control panel, while firmly gripping the operator handle and positioning the chair near the
stairs.
10.
Guide the chair up the stairs, always keeping your hands on the operator handle.
11.
When you reach the top of the stairs, continue going back until the chair is completely on a flat surface and a safe distance
from the stairs.
12.
Push the operator handle forward to rest the chair on all four wheels.
13.
Turn power OFF on control panel.
14.
Apply both rear wheel brakes.
15.
Fold tracks in to an upright and locked position, using the red track release bar.
16.
Release both rear wheel brakes.
17.
Fold out two rear handles and lock into position to transport the chair on flat surfaces to your destination.
NOTE:
While it is possible for one person to operate the chair, we highly recommend using a second operator to stand to assist as
needed and as an emergency back-up. The second operator may use the bottom front extension handles to assist in guiding
the chair when power is not available.
DESCENDING STAIRS
1.
Move the stair chair a few inches from the top step, facing the staircase.
2.
Make sure your patient is secure in the chair, double check safety restraint.
3.
Move the stair chair a few inches from the top step, facing the staircase.
4.
Apply both rear wheel brakes.
5.
Push the red track release bar towards the arrow to release and lower the tracks.
6.
Pull the tracks away from the chair until they lock into place in the proper position for the stairs.
7.
Extend the operator handle to the maximum locked position.
8.
Release both rear wheel brakes.
9.
Use the operator handle to lean the chair back until the track is at the same angle as the stairs, and the tips of the tracks are
resting on the floor.
10.
Turn ON track system by pressing the red power button on control panel.
11.
Press the green DOWN button on control panel.
12.
Pull the operator handle down to keep the track flush against the stairs.
13.
When you reach the bottom of the stairs and back wheels touch the level surface at the base of the stairs, use the operator
handle to push the stair chair into an upright position to resting on all four wheels.
14.
Turn power track system OFF by pushing the red power button on the control panel.
15.
Using the red track release bar fold the tracks into an upright and locked position.
16.
Take patient to destination; apply both rear wheel brakes before your patient disembarks from the chair.
LINE2design, Inc.
1500 Crafton Avenue, Building 128
Mentone, CA 92359
909-798-1829
www.LINE2design.com www.LINE2EMS.com