Erasing HomeLink
姞
buttons
To erase the three programmed
buttons (individual buttons cannot
be erased):
•
Press and hold the two outer
HomeLink
威
buttons until the
indicator light begins to
flash-after 20 seconds. Release
both buttons. Do not hold for
longer that 30 seconds.
HomeLink
威
is now in the train (or learning) mode and can be
programmed at any time beginning with Step 1 in the
Programming
section.
Reprogramming a single HomeLink
姞
button
To program a device to HomeLink
威
using a HomeLink
威
button previously
trained, follow these steps:
1. Press and hold the desired HomeLink
威
button.
Do NOT
release the
button.
2. The indicator light will begin to flash after 20 seconds. Without
releasing the HomeLink
威
button, follow Step 1 in the
Programming
section.
For questions or comments, contact HomeLink
威
at
www.homelink.com
or
1–800–355–3515.
POSITIVE RETENTION FLOOR MAT
WARNING:
Do not install additional floor mats on top of the
factory installed floor mats as they may interfere with the
accelerator or the brake pedals.
Driver Controls
137
2011 MKT
(mkt)
Owners Guide, 1st Printing
USA
(fus)