5. The doors will again lock then unlock to confirm that your personal
entry code has been programmed to the module.
•
Do not use five numbers in sequential order.
•
The factory set code will work even if you have set your own personal
code.
Erasing personal code
1. Enter the factory set 5–digit code.
2. Within five seconds, press the 1
•
2 on the keypad and release.
3. Press and hold the 1
•
2 for two seconds. This must be done within
five seconds of completing Step 2.
Your personal code is now erased and only the factory set 5–digit code
will work.
Anti-scan feature
If the wrong code has been entered seven times (35 consecutive button
presses), the keypad will go into an anti-scan mode. This mode disables
the keypad for one minute and the keypad lamp will flash.
The anti-scan feature will turn off after:
•
one minute of keypad inactivity,
•
pressing the
control on the remote entry transmitter,
•
or the ignition position changes.
Unlocking and locking the doors and liftgate using keyless entry
To unlock the driver’s door,
enter the factory set 5-digit code or your
personal code. Each number must be pressed within five seconds of each
other. The interior lamps will illuminate.
To unlock all doors and liftgate,
press the 3
•
4 control within five
seconds of entering the factory set 5-digit code or your personal code.
To lock all doors and liftgate,
press the 7
•
8 and the 9
•
0 at the
same time.
Note:
The driver’s door must be closed. You
do not
need to
enter the keypad code first.
To open the liftglass,
press the 5
•
6 after entering the factory set
5-digit code or your personal code.
2009 Navigator
(nav)
Owners Guide, 2nd Printing
USA
(fus)
Locks and Security
145
