English 12 English
The user can set functions:
Basic menu
Advanced menu
The
welding
current
Switch on / switch off
the output voltage on
the output lead
The
welding
current
Switch on / switch off
the output voltage on
the output lead
HOT
START
ARC
FORCE
ARC FORCE
: The output current is temporarily increased
to clear short circuit connections between the electrode
and the workpiece.
HOT START
: Value in percentage of nominal value
welding current during arc start current. The control is
used to set the level of the increased current and arc start
current is made easy.
Welding GTAW Process
SPEEDTEC 215C
can be used to GTAW process with DC
(-). Arc ignition can be achieved only by lift TIG method
(contact ignition and lift ignition).
SPEEDTEC 215C
does not include the torch to GTAW
welding, but the one can be purchased separately. See
"Accessories" chapter.
Procedure of begin welding of GTAW process:
First turn the machine off.
Connect GTAW torch to [6] output socket.
Connect the work lead to [5] output socket.
Connect the work lead to the welding piece with the
work clamp.
Install the proper tungsten electrode in the GTAW
torch.
Turn the machine on.
Set the welding parameters.
The welding machine is now ready to weld.
WARNING
Do not kink or pull cable around sharp corners.
By applying the principle of occupational health and
safety at welding, welding can be begun.
During welding GTAW process, the user can set function:
Basic menu
Advanced menu
The
welding
current
Switch on / switch off
the output voltage on
the output lead
The
welding
current
Switch on / switch off
the output voltage on
the output lead
Memory – Save, Recall, Delete
SPEEDTEC 215C
enables saving, recalling and deleting
the parameter’s settings. 9 memories can be used by
user.
Saving, recalling and deleting process settings is
accessible in advanced menu of
SPEEDTEC 215C
.
Error Messages
Figure 8
This image above shown on the display [2] indicates that:
the machine is overloaded or that the cooling is not
sufficient.
When the wire drive motor is stuck
When the output is shorted for more than 5s.
001
Figure 9
When the message as in the figure 8 will be shown on the
display [2] (or the message with similar code number)
contact with the Technical Service Center or Lincoln
Electric.
Sleep Mode
When the machine is turned on but not in use for longer
than 10 minutes, sleep mode is actrivated to save power.
During Sleep Mode logo “Lincoln Electric” moves onto the
display [2].
Figure 10
Restart the machine by pressing a button on MIG torch or
by pressing the right button [8] on front panel.
Содержание SPEEDTEC 215C AUS
Страница 10: ...English 8 English Table 1 Positive polarity factory setting Table 2 Negative polarity WORK LEAD WORK LEAD ...
Страница 18: ...English 16 English Quick Guide ...
Страница 19: ...English 17 English ...
Страница 20: ...English 18 English ...