Lincoln Electric SAE-400 SEVERE DUTY IM727, Руководство оператора

Страница: 8 / 60

A-2
INSTALLATION SAE-400
®
SAFETY PRECAUTIONS
Read this entire installation section before you start installation.
Do not attempt to use this equipment until you have thoroughly
read all operating and maintenance manuals supplied with your
machine. They include important safety precautions, detailed
engine starting, operating and maintenance instructions and parts
lists.
ELECTRIC SHOCK can kill.
• Do not touch electrically live parts such
as output terminals or internal wiring.
• Insulate yourself from the work and
ground.
Always wear dry insulating gloves.
ENGINE EXHAUST can kill.
• Use in open, well ventilated areas or
vent exhaust outside
• Do not stack anything near the engine.
MOVING PARTS can injure.
• Do not operate with doors open or
guards off.
• Stop engine before servicing.
• Keep away from moving parts
Only qualified personnel should install, use or service this
equipment
LOCATION/VENTILATION
The welder should be located to provide an unrestricted flow of
clean, cool air to the cooling air inlets and to avoid restricting the
cooling air outlets. Also, locate the welder so that the engine
exhaust fumes are properly vented to an outside area.
DO NOT MOUNT OVER
COMBUSTIBLE SURFACES
Where there is a combustible surface directly under
stationary or fixed electrical equipment, that surface should
be covered with a steel plate at least .06”(1.6mm) thick,
which should extend not less than 5.90(150mm) beyond the
equipment on all sides.
STACKING
These machines cannot be stacked.
ANGLE OF OPERATION
To achieve optimum engine performance the machine should be
run in a level position. The maximum angle of operation for the
Perkins engine is 30 degrees in all directions. If the engine is to be
operated at an angle, provisions must be made for checking and
maintaining the oil level at the normal (FULL) oil capacity in the
engine crankcase. When operating the welder at an angle, the
effective fuel capacity will be slightly less than the specified 22.5
gallons.
LIFTING
The equipment lift bail should be used to lift the machine.
FALLING EQUIPMENT can cause injury.
• Lift only with equipment of adequate
lifting capacity.
• Be sure machine is stable when lifting.
• Do not lift this machine using lift bail if it
is equipped with a heavy accessory such
as a trailer or gas cylinder.
• Do not lift machine if lift bail is damaged.
• Do not operate machine while suspended from lift bail.
WARNING
WARNING
CAUTION