Lincoln Electric SAE-400 SEVERE DUTY IM727, Руководство оператора

Страница: 12 / 60

B-1
OPERATION
OPERATION
Read this entire installation section before you start installation.
SAFETY INSTRUCTIONS
Do not attempt to use this equipment until you have
thoroughly read all operating and maintenance manuals
supplied with your machine. They include important safety
precautions, detailed engine starting, operating and
maintenance instructions and parts lists.
ELECTRIC SHOCK can kill.
• Do not touch electrically live parts or
electrodes with your skin or wet clothing.
• Insulate yourself from the work and
ground.
• Always wear dry insulating gloves.
• Do not use AC welder if your clothing, gloves or work
area is damp or if working on, under or inside
workpiece.
Use the following equipment:
• Semiautomatic DC constant voltage (wire) welder.
• DC manual (stick) welder.
• AC welder with reduced voltage control.
ARC RAYS can injure eyes and
burn skin.
Wear eye, ear, and body protection.
• Only qualified personnel should install, use or
service this equipment.
• Consult instruction manual before operating.
Before operating, read and understand the manufacturers
instructions for this equipment and the consumables to be
used including the Material Safety Data Sheet (MSDS) and
follow your employer’s safety practices.
FUMES AND GASES can be
dangerous to your health.
• Keep your head out of fumes.
• Use enough ventilation or exhaust at the
arc, or both, to keep the fumes and gases
from your breathing zone and general area.
WELDING SPARKS can cause fire
or explosion.
• Do not weld near flammable material .
• Do not weld on containers that have
held flammable material.
MOVING PARTS can injure.
• Keep away from moving parts
• Do not operate with doors open or
guards off.
• Stop engine before servicing.
ENGINE EXHAUST can kill.
• Use in open, well ventilated areas or vent
exhaust outside.
ADDITIONAL SAFETY PRECAUTIONS
Always operate the welder with the hinged doors closed as these
provide maximum protection from moving parts and insure proper
cooling air flow.
Read carefully the Safety Precautions page in the Instruction
Manual before operating this machine. Always follow these and
any other safety procedures included in this manual and in the
engine instruction manuals.
GENERAL DESCRIPTION
The SAE-400 ® is a diesel engine driven welding power source.
The machine uses a DC generator for DC stick electrode welding
and an AC exciter for 115/230 VAC auxiliary power. As a
generator it can supply up to 3,000 watts of 115/230 volt AC
power. As a welder it provides up to 575 amps of DC constant
current output.
The engine 1104A-44 is a 64.4 Hp @ 1710 RPM (48kw),
4-cylinder water cooled diesel made by Perkins.
SAE-400
®
WARNING