Lincoln Electric OUTBACK 200 CE, Руководство оператора

Страница: 23 / 30

20
Spark Arrester Cleaning & Inspection
1- Use a brush to remove carbon deposits from
the spark arrester screen. Be careful not to
damage the screen. Replace the spark arrester
if it has breaks or holes Move the throttle lever
to its minimum position
2- Install the spark arrester, muffler protector,
exhaust deflector and muffler in the reverse
order of disassembly
IDLE SPEED
Adjustment
1. Start the engine outdoors, and allow it to warm up to
operating temperature.
2. Move the throttle lever to its minimum position.
3. Turn the throttle stop screw to obtain the standard idle
speed.
Standard idle speed: 1,400 ± 150 rpm
Troubleshooting
Engine will not start
Engine lacks power
FUSE REPLACEMENT
The electric starter relay circuit and battery charging
circuit are protected by a fuse. If the fuse burns out, the
electric starter will not operate. The engine can be
started manually if the fuse burns out, but running the
engine will not charge the battery
1. Remove the 6×12 mm special screw from the rear
cover of the engine switch box, and remove the rear
cover.
2. Remove the fuse cover, then pull out and inspect the
fuse.
If the fuse is burnt out, discard the burnt-out fuse.
Install a new fuse with the same rating as the one that
was removed, and reinstall the cover.
Never use a fuse with a rating greater than the one
originally equipped with the engine. Serious damage
to the electrical system or a fire could result.
3. Reinstall the rear cover. Install the 6×12 mm screw and
tighten it securely.
Possible Cause Correction
Battery discharged. Recharge battery.
Fuse burnt out. Replace fuse. (p. 15).
Fuel valve lever OFF. Move lever to ON position.
Choke OPEN.
Move lever to CLOSED position
unless the engine is warm.
Engine switch OFF. Turn engine switch to ON
position.
Engine oil level low (Oil Alert
models). Fill with the recommended oil to
the proper level (p. 9).
Out of fuel. Refuel (p. 8).
Bad fuel; engine stored without
treating or draining gasoline, or
refueled with bad gasoline. Drain fuel tank and carburetor (p.
14). Refuel with fresh gasoline
(p. 8).
Spark plug faulty, fouled, or
improperly gapped. Gap or replace spark plug
(p. 12).
Spark plug wet with fuel
(flooded engine). Dry and reinstall spark plug. Start
engine with throttle lever in
MAX. position.
Fuel filter restricted, carburetor
malfunction, ignition malfunction,
valves stuck, etc. Take engine to your servicing
dealer, or refer to shop manual.
Possible Cause Correcti
on
Filter element(s) restricted.
Clean or replace filter
element(s) (p. 10 -11).
Bad fuel; engine stored without
treating or draining gasoline, or
refueled with bad gasoline. Drain fuel tank and carburetor
(p. 14). Refuel with fresh
gasoline (p. 8).
Fuel filter restricted, carburetor
malfunction, ignition malfunction,
valves stuck, etc. Take engine to your servicing
dealer, or refer to shop manual.