Lince ZENITH GOLD 869 Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 19 / 20

19
LINCE ITALIA S.p.A.
The terminals of the control panel to which the board is connected are shown in the following table
Table 14 -
TERMINAL
BLOCK
DESCRIPTION
TERMINAL
BLOCK
DESCRIPTION
12 V Power supply PR1 ÷ PR3 Arming commands 1 to 3
Reference mass PRT Total program arming command
1 ÷ 4 Wired inputs ST System status
AS - AS Tamper line Reference mass
The following diagram shows an example of connection of the master board with three other slave boards using the cable supplied
with the same slave boards.
12V 1 2 3 4 5 6 7 8
01 02 03 04 +OFF I1 I2
AL BA S AS AS
TP
1 2 3 4 5 6 7 8
TP
1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8
TP
TP
Fig. 28
9588-GOLD-TXRX-M 9589-GOLD-TXRX-S 9589-GOLD-TXRX-S 9589-GOLD-TXRX-S
When one or more slave boards are connected, it is necessary to set the correct address of the board simply by positioning the jumper
on two different pins depending on the boards
SLAVE 1 SLAVE 2 SLAVE 3 M A S T E R
1 2 3 4 5 6 7 8
AL
1 2 3 4 5 6 7 8
AL
Fig. 29
In the case of the SLAVE2 board,
the jumper must be connected to
the EXP3 position.
1 2 3 4 5 6 7 8
AL
EXP4 EXP3
In the case of the SLAVE1 board,
simply remove the jumper.
1 2 3 4 5 6 7 8
AL
EXP4 EXP3
EXP4 EXP3
1 2 3 4 5 6 7 8
AL
EXP4 EXP3
In the case of the SLAVE3 card,
the jumper must be connected to
the EXP4 position.
NOTES :
• In order to ensure correct recognition of the sequence of inputs, it is necessary
to comply with the above and in the order indicated. In the case of connection,
for example of two expansions, the slave connected directly to the master must
have the jumper disconnected, while the one connected to the first must have
the jumper inserted in the “EXP3” position;
• The connections of the slave cards cannot be made “hot”, therefore it is neces-
sary to disconnect the power supply from the master card, connect the slave
cards and power the master card again.