IS141 ECN 2740
5
Please ensure that the gas isolation valve for the appliance is turned to the open position before
attempting to light this unit.
1)
Pass the piezo ignitor wand through the access holes in the rear of the drain tray and
down
the ignition guide channel until it reaches the stop point.
2)
With the control knob in the OFF position, depress the control knob fully, to allow gas
through to the pilot burner, hold in and turn anti-clockwise to the pilot position.
3)
Slowly click the Piezo ignitor wand until the pilot is lit.
4)
Keep the control knob depressed for 20 seconds to establish the pilot light.
5)
Should the pilot fail to remain lit, return the control knob to the OFF position and repeat the
process.
6)
Repeat steps 1 –5 to light the pilot to the second set of burners.
NOTE: The OG7402 Chargrill has two sets of controls and dual pilots. Ensure that both pilots
are lit before lighting the main burners. The left hand control knob controls the larger, left
hand cooking zone of 3 burners which is 60% of the full grid. The right hand control knob
controls the 2 right hand burners, or 40% of the grid.
7)
To light the main burner, turn the control knob anti-clockwise to the high setting.
Note: On
the high setting, the chargrill will take approximately 20 minutes to achieve full
working temperature from cold.
NOTE: This appliance must not be used (or left) with the control knobs positioned between
the pilot position and the full on position.
8)
To run the appliance on low, turn the control knob
fully anti-clockwise to the LOW setting.
9)
The heat input can now be adjusted between High and Low settings to give the desired
working temperature.
10)
Repeat steps 7 – 9 to light the second set of burners.
Warning: Never attempt to light the burners through the heat transfer fins.
Standby
Once the pilots are lit whole or part of the unit can be left on standby by leaving the control knob in
the pilot position. The pilot light(s) will remain lit but the burners will be shut down.
Shutting down the appliance
To turn the appliance off completely turn the control knob(s)
clockwise to the to the OFF position.
Warning: After operation, some parts of the appliance will remain hot for a period of time.
Please take care to avoid accidental burns.
Cleaning
Ensure gas supply is isolated before commencing cleaning.
After complete shut down and cooling parts of this unit can be dismantled for cleaning, in the
following order: Refer to Assembly of Enclosures diagram.
