Linak TWINDRIVE TD32, Руководство пользователя

Страница: 7 / 32

Warning!
If any of the TWINDRIVE ® products are opened, there will be a risk of
subsequent malfunction. Furthermore, the warranty will not cover, when
the product has been opened by unautorised personnel.
The TWINDRIVE ® systems do not withstand cutting oil.
• Statement – for all intentional and unintentional radiators:
Changes or modifi cations not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
• Statement for digital devices for Class B:
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio fre-
quency energy and, if not in-stalled and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equip-
ment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
Repairs
In order to avoid the risk of malfunction, all TWINDRIVE
®
repairs must only be
carried out by authorised LINAK workshops or repairers, as special tools must be
used and special gaskets must be fi tted. TWINDRIVE under warranty must also be
returned to authorised LINAK workshops.
Before start-up:
• Make sure that the system has been installed as instructed in this User Manual.
• Make sure that the voltage is correct before the system is connected to the mains.
(See TD3 label on page 22).
• System connection. The individual parts must be connected before connection to
the
mains.
During operation
• Take care that the cables are not damaged or get jammed.
• The products must only be used in an environment, which corresponds to their IP
protection or where no IP protection is required.
7