Dome Setup (Fast Dome)
Matrix can connect to Fast Dome Cameras. 128 preset positions can be set for a Fast Dome Camera.
As follows:
1. Press numeric key 7 to enter DOME SETUP from SETUP MENU.(set preset positions)
2. If a Fast Dome was set as 1st Camera, Press numeric key 1 followed by ENT key for DOME NO, to
connect matrix with 1st Camera(Fast Dome).
Press numeric key 0 for RESET. (Not to clear preset data) If numeric key 1 is pressed for RESET, all
128 preset data will be deleted.
To set 1~16 preset position as follows:
Press numeric key 1 followed by ENT key to select 1st preset position. (1~16 preset positions can be
set, but 17~128 preset positions can be set differently according to next page)
Move Joystick to position camera to desired viewing angle.
Adjust ZOOM IN/ZOOM OUT.
Adjust FOCUS FAR/FOCUS NEAR or AUTO FOCUS.
It is recommended using manual focus mode when setting up presets to maintain optimal focus level.
Adjust IRIS O/IRIS C or AUTO IRIS for optimum picture.
Set dwell time.
Press numeric key 3 followed by ENT key to set time as 3sec.(Time can be set from 3sec~255sec)
Set the speed of moving from previous preset point to current preset point.
Press numeric keys 2 5 5 followed by ENT key to set speed as 255 /sec.
(Speed can be set from 1 /sec ~ 255 /sec)
Save data
Press PRESET key on the keyboard to save the above data.
Press ESC key returning to step2. Step2 to step5 can be repeated for more setup.
Press ESC key again to escape.
DOME SETUP
DOME SETUP
DOME NO
1
RESET < Y/N >
N
PRESET NO
< 1 TO 128 >
DWELL <SEC.>
< 0 TO 255 >
SPEED <1/SEC.>
DOME NO
1
RESET < Y/N >
N
PRESET NO
1
< 1 TO 128 >
DWELL <SEC.>
3
< 0 TO 255 >
SPEED <1/SEC.>
255
SAVE DATA
SETUP MENU
1. SYSTEM SETUP
2. SEQUENCE TABLE
3. MONITOR SETUP
4. ID & RECEIVER SETUP
5. ALARM SETUP
6. ALARM TIME SETUP
7. DOME SETUP
ENTER ITEM
7
13
