www.liko.com
70
10.0
Periodic Inspection
Periodic Inspection
Declaration for protocol Checklist LikoLight
1 Check mast and base frame for visible damage to the lift surfaces, finish, etc
- Check for scratches, dents, deformities or unusual surface wear.
2 Check caster wheels
- Roll the lift, unloaded, along the floor, checking to ensure that all casters roll and turn freely.
- Verify that the caster fasteners are tight. There should not be any play between the fork and the caster nut.
- Remove the front fork cover and inspect safety casing and bolt for cracks or fractures.
3 Check the caster brakes
Lock the brakes. Make sure the wheels do not turn and the caster housing does not swivel when the lift is pushed.
4 Inspect the base covers.
- Inspect the plastic protective cover shells for cracks, deformation or gaps.
5 Inspect base opening and closing linkage
Manual Base:
-Inspect foot pedal for wear/sharp-edges
-Press the right side to widen the base and the left side to make it narrower.
-Inspect linkage arms and ball coupling hardware.
-Verify base manually opens & closes to max. & min. dimensions
6 Inspect Locking Handles
- Loosen & retighten locking handles. Verify that threads are not damaged or binding.
7 Inspect the lift arm hardware and covers
- With the lift in it’s lowest position, manually raise the lift arm/boom. Verify that the shaft lowers and raises freely.
If the arm is binding, the mounting screw is too tight.
- Inspect the plastic protective cover shells for cracks, deformation or gaps.
- Inspect welding between arm and fastening device actuator.
8 Inspect the Flexlink arm to mast hardware and covers
- With the slingbar hanging in it’s lowest position, manually raise the slingbar and flexlink arm.
- Verify that the flexlink arm lowers and raises freely. If the flexlink is binding, the screw is too tight.
- Inspect the plastic protective cover shells for cracks, deformation or gaps.
9 Inspect the Flexlink arm to slingbar hardware and covers
- With the slingbar hanging in it’s lowest position, manually pivot the slingbar side-to-side. Verify that the flexlink arm
lowers and raises freely. If the flexlink is binding, the mounting screw is too tight.
- Verify that hardware covering plastic caps are secure.
10 Inspect the slingbar w/safety latches
- Inspect visually to ensure that the steel hanger bars are free from any scratches, sharp edges or deformities.
- Verify the o-ring is present and positioned in the center bolt groove.
- Check that the unit rotates freely on its bearings. Wipe of any dirt, dust or residue.
- Make sure that both safety latch clips are mounted and fall back against the body of the slingbar.
