www.liko.com
71
10.0
Periodic Inspection
Periodic Inspection
Declaration for protocol Checklist LikoLight
11 Inspect the mast actuator w/mechanical lowering device
- Verify that the upper and lower actuator fasteners to the mast are tight.
- Check that the locking screws on the emergency-lowering device are
countersunk; screw heads must not protrude.
12 Check battery & electrical cable installations
- Verify that battery is charged (recharge battery or test w/Prod. No 2101100).
- Verify that all cables are properly inserted. Reinsert if uncertain.
13 Check all functions on the handcontrol
- With the emergency stop out, verify that all functions on the handcontrol are working.
14 Check the Emergency Stop function
- Press in the emergency stop button. With the emergency stop pressed in, verify that the lift does not operate with
the hand control buttons.
- Next, turn the red emergency stop button in the direction of the arrows (clockwise). Verify that the button releases
from the locked position into the raised, open position.
15 Check electrical emergency lowering device functions
- With the emergency stop out, verify that the electrical emergency lowering device functions.
16 Check charger function
- Insert the cable into a power outlet (110-240V).
- Remove the battery pack from the lift by raising the catch at the back of the battery pack and lifting upwards.
Place the battery pack on the charger. Check that the charger is plugged into the wall socket and that the diods on
the front of the charger lights up (indicates charging).
17 Type/model identification decal
- Verify presence of mast decal with model type and serial number.
18 Check base frame castor play and levelling
- Roll the lift along a level floor surface and check to ensure thath the distance between the wheels and the floo
does not exceed 6mm / 0,24 inch.
19 Mast Max. Load Test
- Run the lift with maximum load (140kg / 308lbs) all the way up and down.
- Listen for peculiar noises and vibrations.
20 Base Max. Load Test
- Press right / left side to widen the base with maximum load (140kg / 308lbs).
- Listen for peculiar noises and vibrations.
21 Mechanical Emergency Lowering Load test
- Check to ensure that the mechanical emergency lowering device functions with load (140kg / 308lbs).
- Manually turn the red actuator collar in the direction of the arrows(Clockwise) to lower.
22 Documentation
-
Instructions / Instruction guide/Service Manual
