EM58 – HS58 - HM58 MODBUS TCP/IP
NOTE
Please note that the Preset value is now saved temporarily in the
registers. To save permanently the set Preset value in the
Save Preset
button. Should the
power supply be turned off without saving data, the Preset value that has not
been saved on the Flash EEProm will be lost! For more information refer to the
After saving the Preset value, you must activate it (see the
command in the
Press the
Activate Preset
button to activate the preset value. The Preset value
will be set for the position of the encoder in the moment when the
Activate
Preset
button is pressed. We suggest activating the preset value when the
encoder is in stop.
NOTE
At each confirmation of the Preset setting and activation, a message will
appears in the
No Command sent
line. It informs whether the operation has
been accomplished properly or an error occurred.
Press the
Homepage
command to move back to the Web server Home page.
8.6 Setting the registers
Press the
Set Registers
command in the left navigation bar of the Web server
Home page to enter the
Set Encoder Registers
page. In this page the read-
write access MODBUS registers are displayed and their value can be changed.
For complete information on the available holding registers please refer to the
“7.1.1 Holding Register parameters” section on page 51.
A soon as you press the
Set Registers
command a warning message (
Are you
sure you want to change Registers Values?
) appears on the screen: it warns
the operator about the awkwardness of the operation, thus he is required to
confirm the procedure before continuing.
MAN EM58_HS58_HM58 MT E 1.1.odt
Integrated web server
81 of 104
Содержание EMC58 MT
Страница 101: ...This page intentionally left blank ...
Страница 102: ...This page intentionally left blank ...
Страница 103: ...This page intentionally left blank ...