Lika DRAW WIRE SFA-10000 Series, Руководство пользователя, Страница: 31 / 72

SFA-5000 • SFA-10000 Profibus
EXAMPLE
Set the node address = 25:
25
10
= 0001 1001
2
(binary value)
bit 1 2 3 4 5 6 7 8
2 0 2 1 2 2 2 3 2 4 2 5 2 6
ON OFF OFF ON ON OFF OFF OFF
Set the node address = 55:
55
10
= 0011 0111
2
(binary value)
bit 1 2 3 4 5 6 7 8
2 0 2 1 2 2 2 3 2 4 2 5 2 6
ON ON ON OFF ON ON OFF OFF
WARNING
This device is designed to allow the node address setting also via software by
means of the Service Access Point SAP55 Set_Slave_Address. For any
information please refer to the “5.4 Setting the node address via BUS (SAP55
service)” section on page 40 and to the “6.8 Set_Slave_Address command
(SAP55 service)” section on page 64.
NOTE
After having set the device address, please check the bus termination switch
position (see the “4.9 RT Bus termination (Figure 3 and Figure 4)” section on
page 32).
4.8 Baud rate
The baud rate is set by the Master via software at configuration of the node
(Slave).
This device supports the following baud rates (they are listed in the .GSD file
too):
9.6 kbit/s, 19.2 kbit/s, 93.75 kbit/s, 187.5 kbit/s, 500 kbit/s, 1.5 Mbit/s, 3 Mbit/s, 6
Mbit/s, 12 Mbit/s.
MAN SFA_5000_10000_PB E 1.0 Electrical connection 31 of 72