3
Operational Instructions
Energizing System
1. Check if the EB is disconnected from mains supply before connecting
cables to the lamp head.
2. Check if the main circuit break switch of the EB is in the off position
3. Confirm if the lamp head meets the requirements of the EB
4. Check the lamp head cable for visible damages
5. If you followed all of these quick checks, you can connect the EB to
the mains supply and connect the lamphead.
6. You are now ready to start the EB and change the settings.
Adjusting the System
1. After preparing everything, you can now change your settings on the
display of the EB.
2. The LCD display turns on when the main circuit breaker is in the ON
position.
3. It should light up the L3 indicator (green)
4. If ground connection is correct, L4 indicator is on. If this is not the
case, check the power supply and socket.
5. Turn on the ignition switch to ON - the light will ignite within 3 se-
conds. At the same time, L1 indicator turns on (yellow)
6. Wait for 3 minutes until the lamp is fully heated and the color tempe-
rature and brightness have a stable output. Then you can adjust the
brightness value and frequency as needed.
Содержание LIGHTMAN 25 EB
Страница 1: ...LIGHTMAN 25 40 EB User Manual...
Страница 2: ...User Manual Version 23 Dezember 2021 3 52 PM Lightstar Lights info lightstar lights com...
Страница 12: ......