2.06/2.54
AUDIO OUTPUT
DC POWER
16V/1A
CHARGE
LEVEL
MIC LINE
CHANNEL A
CHANNEL B
SENSOR INPUTS
SHORT
BALANCED
AUDIO
OUTPUTS
+
—
800iX User Manual | 11
10 | 800iX User Manual
8 0 0 i X U s e r M a n u a l
8 0 0 i X U s e r M a n u a l
CHARGING THE LIGHTMIC
Do not attempt to charge alkaline batteries.
They can overheat and expand, creating a
significant hazard and damaging the LightMic.
(This is not covered by the warranty.)
Helpful Hint
1. Ensure
LightMic is turned OFF
.
2. Connect
one end of the charging cable to the
LightMic and the other end to one of the charger
jacks on the back of the 800iX. The LED on the
front of the LightMic will glow red while charging.
3. Leave
the LightMic plugged in overnight (8–10 hrs.)
to obtain a full charge.
LT-71
OPERATING THE OPTIONAL HM-70 HANDHELD MIC
ON
OFF
MUTE
(Center Position)
3. Grip
the barrel of the HM-70 in the
center section just below the power
switch. Avoid gripping the HM-70
around the base, covering the
infrared emitters. This could interrupt
signal transmission from the micro-
phone to the receiver.
4. Speak
directly into the microphone
at a normal level. Slowly increase
the B VOLUME until you can just
hear your voice.
5. Slide
the switch to the OFF position
to turn off the HM-70. (Make sure the
power indicator light is off.)
The Channel A/B switch is located
inside the battery compartment.
The switch is set to Channel B at
the factory.
1. Slide
the power switch on the side
of the HM-70 all the way up. The
power indicator LED will glow red
and stay on.
2. The center
position of the power
switch is MUTE. When in this mode,
the HM-70 is transmitting a signal,
but no audio can be heard through
the system. This is useful if you
wish to temporarily turn audio off
during a private conversation.
