SYSTEM OPERATION
TURNING THE SYSTEM ON
4.
While
speaking in a normal voice,
increase the A VOLUME level until
your voice is barely audible.
Remember!
This equipment is
designed to supplement and distribute
the end user’s voice so he or she is able
to speak at a conversational tone.
Having the volume set too high will
result in feedback and listener fatigue.
2. Slip
the LT-71 LightMic with lanyard
around the neck and position the top of
the microphone just below the collarbone.
Note: Positioning of the LightMic is critical
for proper volume adjustment.
LT-71
1. Turn
the 800iX switch to the ON position. The red LED on the switch will glow.
3. Turn
on the LightMic and set the operating
channel to “A.” This microphone will be
designated as the “Teacher Mic.”
6. If
a
second student pass-around microphone
was purchased with the system, repeat steps
3-4 but set the operating channel to “B.”
(If a HM-70 was purchased, see page 16.)
A CH B
OFF ON
>>
>>
>>
>>
>>
A CH B
OFF ON
8 | 800iX Users Manual
800iX Users Manual | 9
8 0 0 i X U s e r M a n u a l
8 0 0 i X U s e r M a n u a l
2. Connect
the charging cables to yellow
charging jacks labeled “CHARGERS.”
The loose end will be connected to
the charging jack on the microphone.
1. Ensure
the power switch is in the “OFF” position and all front panel volume
controls are turned fully counter-clockwise.
4. Connect
DC end of power supply
to the black power jack labeled
“DC POWER.”
FINALIZING RECEIVER CONNECTIONS
INITIAL SET-UP
5. Connect
the black AC power cable
from the power supply to a wall outlet.
1. Ensure
all cables are appropriately routed out of walking paths and work areas to
prevent safety hazards to individuals in the room.
2. The amplifier packing material should be kept for warranty shipping purposes.
Dispose of remaining system-packing material in the appropriate refuse containers.
Leave microphones charging so they are ready for use. Microphones will need to be
charged on a daily basis.
FINAL CHECK
2.06/2.54
AUDIO OUTPUT
DC POWER
16V/1A
CHARGE
LEVEL
MIC LINE
CHANNEL A
CHANNEL B
SENSOR INPUTS
SHORT
BALANCED
AUDIO
OUTPUTS
+
—
2.06/2.54
AUDIO OUTPUT
DC POWER
16V/1A
CHARGE
LEVEL
MIC LINE
CHANNEL A
CHANNEL B
SENSOR INPUTS
SHORT
BALANCED
AUDIO
OUTPUTS
+
—
2.06/2.54
AUDIO OUTPUT
DC POWER
16V/1A
CHARGE
LEVEL
MIC LINE
CHANNEL A
CHANNEL B
SENSOR INPUTS
SHORT
BALANCED
AUDIO
OUTPUTS
+
—
3. Ensure
sensor cable is
attached securely.
