READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This luminaire is intended for installation in accordance with the National Electrical Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector before
installation. To prevent electric shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
IS:40421
C1101
Page 2 of 2
A
COMPANY
631 Airport Road, Fall River, MA 02720
FIG. 7
FIG. 6
FIG. 4
FIG. 5
FOAM
GASKET
NECK
TAB
NOTCH
SLOT
COLLAR
PIN
COLLAR
SOCKET
MOUNTING
PLATE
SOCKET
SUPPORT
SPRING
CROSSBLADE
LOUVER
TAB
SUPPORT PLATE
SCREW
REFRACTOR
SUPPORT PLATE
SOCKET
MOUNTING
PLATE
FINAL HEIGHT ADJUSTMENT AND INSTALLATION:
1.
Adjust luminaire to final height: To raise POWERHEAD push down on KNURLED RING on
CABLE ADJUSTER and push SUPPORT CABLE into CABLE ADJUSTER. To lower
POWERHEAD, push down on KNURLED RING on CABLE ADJUSTER and allow SUPPORT
CABLE to come out of CABLE ADJUSTER. Fully tighten KNURLED RING on CABLE
ADJUSTER.
2.
Push any excess POWERCORD into hole in CANOPY, secure POWERCORD in place by
wrapping SNAP-IN BUSHING around POWERCORD and push BUSHING into hole in CANOPY
(Fig. 1).
3.
Reinstall DOOR and secure in place by tightening SCREW firmly onto MOUNTING PLATE (Fig.
1).
4.
Follow steps below for REFLECTOR/REFRACTOR installation.
5.
Install recommended lamp(s). Note: On metal halide luminaires with auxiliary lamp option, install
halogen lamp as shown in Fig. 3.
REFLECTOR/REFRACTOR INSTALLATION:
1.
Slide COLLAR up NECK.
2.
Peel off backing from FOAM GASKET and adhere to TABS on REFLECTOR PLATE (Fig. 4).
3.
Tip REFLECTOR/REFRACTOR over REFLECTOR PLATE and allow
REFLECTOR/REFRACTOR to rest on FOAM GASKET.
4.
Secure REFLECTORREFRACTOR in position by aligning SLOT in COLLAR over PINS and
slide COLLAR down NECK. Twist COLLAR counter-clockwise allowing PINS to rest in
NOTCHES (Fig. 5).
12” REFRACTOR SUPPORT PLATE INSTALLATION:
(Required for luminaires using 12” REFRACTORS only)
1.
Align SUPPPORT PLATE over SOCKET MOUNTING PLATE.
2.
Secure SUPPORT PLATE to SOCKET MOUNTING PLATE using two SCREWS provided with
REFRACTOR (Fig. 7).
LENS INSTALLATION (WHEN PROVIDED):
1.
Place lens up into lip of REFLECTOR/REFRACTOR. Secure in place by expanding RING
around outside lip of REFLECTOR/REFRACTOR allowing spring tension of RING to close
around lip (Fig. 1).
CROSSBLADE LOUVER INSTALLATION (when provided):
1.
Hook “J” shaped end of SUPPORT SPRING through the two holes in SOCKET MOUNTING
PLATE as shown in Fig. 6.
2.
While carefully pulling down on SUPPORT SPRING hook “V” shaped end of SUPPORT
SPRING through hole in CROSSBLADE LOUVER.
3.
Carefully allow SUPPORT SPRING to pull CROSSBLADE LOUVER up into REFLECTOR
making certain TABS on CROSSBLADE LOUVER sits securely into recessed LIP of
REFLECTOR (Fig. 6).
CAUTION: MAXIMUM WATTAGE AS MARKED ON LUMINAIRE MUST NOT
BE EXCEEDED.
