Lighthouse Worldwide Solutions REMOTE 1100, Руководство по эксплуатации

Страница: 23 / 70

Get Started
248083363-1 Rev 4 3-3
Figure 3-2 Marking Wall for Mount Point
WARNING:
Make
sure target location is
electrically safe for
drilling. Wear safety
glasses while drilling.
1. Refer to Table 3-1 and Table 3-2 and set the DIP switches to desired
address and communication mode.
2. Level the instrument and mark where mounting holes will be
drilled. Take care to not drop the instrument while marking. Refer
to Figure 3-2.
Figure 3-3 Drilling and Preparing Mounting Holes
3. Use an appropriate size drill to drill the anchor holes.
4. Install the anchors and start button-head screws but o not tighten.
Place R1100/1104 on screws and tighten screws. Use flat washers
to provide a stronger attachment.
5. Find an appropriate area for the power supply and place the supply
so access to the AC input connector is visible. Attach the 24VDC
connector to the REMOTE then attach power cord.
Maintain six
inches between
sides and any
walls or objects
to prevent
overheating
left and right