ASSEMBLY INSTRUCTIONS
10 |
P a g e
Need more help?
Contact us
any time at:
[B]
PART 2 - ASSEMBLY OF YOUR SIT-STAND TABLE
If you’ve purchased the Sit-Stand Kit, please refer to the below instruction as to how to
securely attach your tabletop to the Sit-Stand Mechanism provided with the kit
Tools you will need before starting:
•
#2 Philips-head (Star) Screw driver
•
(optional) C
ordless-drill with a #2 Phillips bit AND a 1/16-in drill bit for pilot holes
A)
STE P 1 – SIT-STAND MECHANISM ASSEMBLY
Open your provided Sit-Stand mechanism box and find the provided assembly tools, hardware and assembly
instruction pamphlet. Please follow the instructions provided in the kit to assemble the mechanism.
B)
STE P 2 – ATTACHIN G THE TABLE TOP
To attach the provided tabletop, first check to see if your provided tabletop has pre-drilled holes in it.
•
If your tabletop has pre-drilled holes, place it face-down onto a clean, flat surface, and rest your sit-stand
mechanism on top (the feet should be pointing upward). You may use the existing holes as a guide when
spreading the sit-stand legs apart. Simply follow the instructions provided with the sit-stand mechanism
and use the provided wood screws to screw the mechanism onto the tabletop as directed.
•
If your tabletop does NOT have pre-drilled holes, place it face-down onto a clean, flat surface, and rest
your sit-stand mechanism on top (the feet should be pointing upward). You will then need to center and
align the legs on your table top and spread the legs to a spacing of
at least 42-in
, wider is preferred for
stability, tabletop permitting
.
Once the legs are centered and spread to an appropriate position, there are
two options:
i)
Mark the holes as directed in the instructions for the sit-stand, and use a drill with a 1/16-in drill-bit
to drill pilot holes for your screws. This will ensure straightness and best security of your desk
ii)
If you do not have access to a drill, the wood screws CAN be screwed in directly to the tabletop
securely using a screwdriver, but the table is less likely to remain centered and there is risk it will
not stay level depending on how flush/straight the screws sit into the tabletop when done by hand
without pilot holes.
C)
STE P 3 – FINISHIN G THE SETUP
Once the tabletop is secured, ask for assistance and flip the table upright. Ensure the tabletop is stable, and test
the controls (either manual or electric) to ensure all mechanisms are functioning properly before putting your
LightBoard onto the desk.
Once the above is confirmed, you may now place your LightBoard safely onto the sit-stand desk and start your first
session!
