1. The installation and use: Please read carefully with the lights attached ‘User Manual’, in strict
accordance with the related manual content to guide the installation and use.
2. To install and use the lights, pay attention to the following points:
◆
The lights installation: the light must be installed on the surface of the solid & noncombustible
object. When the light is hung, it is necessary to verify that the facilities and the light hook can
withstand at least 10 times of lights weight, and add the safety rope and other security measures;
◆
Electrical connections:
◎
The
professional
skill
person
is
required
;
◎
The lighting power connections must be installed in accordance with the relevant standards,
the incorrect power supply connection may lead to damage the light!
◎
Please check whether the power supply voltage and frequency meet the requirements of the
light before power on, and check the power cord connection, whether the plug and socket are
closely connected, each light must be properly grounded;
◎
Please do not use the power cable with damaged insulating layer , if the power cable
insulating layer is damaged, it must be operated by the manufacturer or distributor or a
professional qualification person to avoid danger!
◆
If the lights were controlled by the console, it must be turned on by different groups so as not to
turn on the lights in large quantities and to bring down the city electricity in a flash;
◆
When the light fixture is ON, the projected object should be more than 12 meters distance
to avoiddanger.
◆
The distance between the light fixture and ventilation at least 1 meters, and no obstructions is
allowed.
◆
No
direct
contact
between
lamp
and
eyes
is
allowed
when
the
lamp
is
turned ON.
◆
Don't let the light in long time Power On when the light
fixture
with
failure
issue
;
◎
Correct steps
:
Onced Confirmed the light is not working properly, the power cable and signal
connection should be disconnected from the light,move to the workbench or ground for inspection;
◆
Do not switch on/off the light frequently, even if the lamp is not turned ON or installed, for which
will affect the life span of the fixture.
◆
In long time use, it’s not recommended to use over 4 hours each time, otherwise it will greatly
shorten the service life of light. The alternate operation method can be used to solve Above issue.
◆
Please
cut
off the
power
immediately
if
the light
working
with
some
unusual
noise;
◆
If the light is strongly hit by accident, check the interior of light firstly to make sure there is no
short circuit, no electric leakage. and the lamp is fine. then , test the fixture with Power ON.
◆
Do not pack the lighting fixture into carton or flycase before it is completely cooled;
◆
After the event is finished, we suggest turn OFF the lamp by console, but let the lamp fan keep
working for a few minutes to cool down the fixture interior temperature.the bulb can be off by
console, and let the light continue
◆
When replacing the new lamp, it must be carried out at the condition that the fixture is completely
cooled and power off. Wear clean gloves, check the new lamp to make sure there is no oil stain,
dirt or fingerprints, and wipe them with clean paper or alcohol.
◆
Do not use it in wet, rain, dusty or blown sand situation if there are not enough protections.
◆
When the fixture is accidentally with water intrusion and seriously humid, the power must be cut
OFF immediately, and open cover plate, wipe off the water, and put the light in the outdoor
ventilation area to dry (the cover plate should be opened);
◆
Keep distance from the smoke machine, bubble machine, snow machine and so on to avoid
influence to the lights; if lights must be close to smoke machine, bubble machine, snow machine,
please shorten the cleaning period gab of lights.
The installation and routine maintenance
2
